Explanation
V(rms) = V₀/√2 · 220 V mains
AC voltage swings up and down. The rms value is the steady DC that would heat a resistor equally: peak over root two.
Indian mains, two hundred and twenty volts rms, peaks at about three hundred and eleven.
V(rms) = V₀/√2 · 220 V mains → peak ≈ 311 V
X(L) = ωL (current lags V by 90°) · X(C) = 1/ωC…
An inductor opposes AC more at high frequency: X L equals omega L, and current lags behind voltage. A capacitor is the opposite: X C equals one over omega C, and current leads.
X(L) = ωL (current lags V by 90°) · X(C) = 1/ωC (current leads V by 90°)
Z = √(R² + (X(L) − X(C))²) · tan φ = (X(L) − X(C))/R
In a series LCR circuit, the total opposition is the impedance: root of R squared plus the reactance difference squared. Three and four make five.
Z = √(R² + (X(L) − X(C))²) · tan φ = (X(L) − X(C))/R
Resonance
At one special frequency, the inductor's and capacitor's reactances cancel. That's resonance: impedance is just R and the current peaks.
Radios tune stations this way.
Resonance: X(L) = X(C) → ω₀ = 1/√(LC), Z = R, current maximum
P = V(rms) I(rms) cos φ, cos φ = R/Z · pure L or C
Average power is V rms times I rms times the power factor, cos phi, which is R over Z. A pure inductor or capacitor uses no average power: its current is wattless.
P = V(rms) I(rms) cos φ, cos φ = R/Z · pure L or C: P = 0
Transformer
A transformer changes AC voltage using two coils on one core. The voltage ratio equals the turns ratio.
Step the voltage up and the current steps down, keeping power about the same.
Transformer: V(s)/V(p) = N(s)/N(p) = I(p)/I(s)
Worked example
L = 1 H and C = 1 μF. Resonant ω₀ = 1/√(1 × 10⁻⁶) = 1000 rad s⁻¹; f₀ = 1000/2π ≈ 159 Hz.